Plastic Part Design for Injection Molding
An Introduction
(Sprache: Englisch)
The goal of the book is to assist the designer in the development of parts that are functional, reliable, manufacturable, and aesthetically pleasing. Since injection molding is the most widely used manufacturing process for the production of plastic parts,...
lieferbar
versandkostenfrei
Buch (Gebunden)
102.80 €
- Lastschrift, Kreditkarte, Paypal, Rechnung
- Kostenlose Rücksendung
- Ratenzahlung möglich
Produktdetails
Produktinformationen zu „Plastic Part Design for Injection Molding “
The goal of the book is to assist the designer in the development of parts that are functional, reliable, manufacturable, and aesthetically pleasing. Since injection molding is the most widely used manufacturing process for the production of plastic parts, a full understanding of the integrated design process presented is essential to achieving economic and functional design goals. Features over 425 drawings and photographs.
Klappentext zu „Plastic Part Design for Injection Molding “
The goal of the book is to assist the designer in the development of parts that are functional, reliable, manufacturable, and aesthetically pleasing. Since injection molding is the most widely used manufacturing process for the production of plastic parts, a full understanding of the integrated design process presented is essential to achieving economic and functional design goals. Features over 425 drawings and photographs. Contents: Introduction to Materials. Manufacturing Considerations for Injection Molded Parts. The Design Process and Material Selection. Structural Design Considerations. Prototyping and Experimental Stress Analysis. Assembly of Injection Molded Plastic Parts. Conversion Constants.
Autoren-Porträt von Robert A. Malloy
Dr. Robert Malloy is Professor Emeritus and former Chair of the Plastics Engineering Department at the University of Massachusetts Lowell. He is an active researcher and consultant in the areas of plastics processing, design, and recycling. Dr. Malloy is the author of many publications and patents, including a textbook on the subject of plastic part design. Prior to joining the faculty at Lowell, he was an instructor at the Algerian Petroleum Institute in Annaba, Algeria.
Bibliographische Angaben
- Autor: Robert A. Malloy
- 2010, 2nd ed., XIV, 554 Seiten, 476 Schwarz-Weiß-Abbildungen, 450 Abbildungen, Maße: 17,2 x 24,6 cm, Gebunden, Englisch
- Verlag: Hanser Fachbuchverlag
- ISBN-10: 3446404686
- ISBN-13: 9783446404687
- Erscheinungsdatum: 07.10.2010
Sprache:
Englisch
Rezension zu „Plastic Part Design for Injection Molding “
"Insgesamt behandelt das Buch eine so große Bandbreite an Themenkomplexen mit vielen Beispielen und Zahlenwerten, dass es nicht nur den direkt angesprochenen Designern, sondern allen weiteren an der Wertschöpfungskette Beteiligten [...] als Lektüre zur Erweiterung des eigenen Horizonts empfohlen werden kann." Manfred Popp, Kunststoffe 6/2011"Die umfangreich Materie wird ausführlich beschrieben, durch viele Illustrationen veranschaulicht und auch theoretisch untermauert." Prof. Johannes Kunz, KunststoffXtra, September 2011
Kommentar zu "Plastic Part Design for Injection Molding"
Schreiben Sie einen Kommentar zu "Plastic Part Design for Injection Molding".
Kommentar verfassen