An Introduction to Well Control Calculations for Drilling Operations

Chapter One - Getting a Handle on Calculations.- Chapter Two - Volume Calculations.- Chapter Three - Pressure Calculations.- Chapter Four - Well Control Calculations.

Dave Cormack has worked in the drilling industry out of Aberdeen, Scotland since 1983. He has worked on over thirty drilling rigs, platforms or MODU's either as a member of the drill crew or in a training capacity. Since 1991 he has been exclusively involved in training drilling personnel either on the rig, in the classroom or in a management capacity worldwide. He served a three-year term on the Board of Directors of the International Well Control Forum and was one of the contributing authors to the Well Control chapter in the recently revised International Association of Drilling Contractors definitive Drilling Manual. He has been involved in well control training on every continent on earth bar the polar ones, has published two SPE papers and made presentations on training at global drilling conferences. Dave still teaches well control regularly to both international certification standards and also runs courses globally, training the next wave of well control assessors for IWCF. He is passionate about helping students through their two yearly well control school and firmly believes that a solid grasp of calculation skills frees them up to concentrate on learning well control.