Hybrid ADCs, Smart Sensors for the IoT, and Sub-1V & Advanced Node Analog Circuit Design

Part I.Hybrid Data Converters.- Chapter 1. HYBRID DATA CONVERTERS.- Hybrid and segmented ADC techniques to optimize power efficiency and area. The case of a 0.076mm2 600MS/s 12b SAR- ADC.- Chapter 3. Interleaved Pipelined Sar Adcs: Combined Power for Efficient Accurate High-Speed Conversion.- Chapter 4.Hybrid Vco Based 0-1 Mash and Hybrid Sar._ Chapter 5. A Hybrid Architecture for a Reconfigurable Sar Adc._chapter 6. A Hybrid ADC for High Resolution: The Zoom ADC.- Part II.Smart Sensors for the IoT.- Chapter 7.Advances in Biomedical Sensor Systems for Wearable Health.- Chapter 8.An Ultra-Lowpower, Robust Photoplethysmographic Readout Exploiting Compressive Sampling, Artifact Reduction and Sensor Fusion.- Chapter 9.A 32kHz-DTCXO RTC Module with an Overall Accuracy of ±1ppm and an All-Digital 0.1ppm Compensation Resolution Scheme.- Chapter 10.Energy-Efficient High-Resolution Resistor-Based Temperature Sensors.- Chapter 11. A High-Resolution Self-Oscillating Integrating Dual-Slope CDC For Mems Sensors.- Chapter 12. Ultra-Low Power Charge-Pump Based Bandgap References.- Part III.Sub-1V & Advanced-Node Analog Circuit Design.-Chapter 13. FD-SOI Technology, Advantages for Analog/RF and Mixed-Signal Designs.- Chapter 14.Analog/Mixed-signal Design In Finfet Technologies.- Chapter 15.Analog circuits in 28nm and 14nm FinFET.- Chapter 16.Pipeline and SAR ADCS for Advanced Nodes.- Chapter 17.Time-Based Biomedical Readout in Ultra-Low Voltage, Small-Scale CMOS Technology.- Chapter 18.A 4.4mW-TX, 3.6mW-RX Fully Integrated Bluetooth Low-Energy Transceiver for IoT Applications.

Pieter Harpe received the M.Sc. and Ph.D. degrees from the Eindhoven University of Technology, The Netherlands. From 2008 to 2011, he was a researcher at Holst Centre / imec, The Netherlands, where he worked on ultra low-power wireless transceivers, with a main focus on ADC research and design. In April 2011, he joined Eindhoven University of Technology as assistant professor on low-power mixed-signal circuits. Since 2012, he is co-organiser of the yearly workshop on Advances in Analog Circuit Design (AACD). In 2013, he became member of the Technical Program Committees of ISSCC and ESSCIRC. He is recipient of the ISSCC 2015 Distinguished Technical Paper Award and serves as an IEEE Solid-State Circuits Society Distinguished Lecturer. He contributed to over 100 scientific papers, 9 books and 7 patents. .

Kofi A. A. Makinwa received the B.Sc. and M.Sc. degrees from Obafemi Awolowo University, Nigeria in 1985 and 1988 respectively. In 1989, he received the M.E.E. degree from the Philips International Institute, The Netherlands and in 2004, the Ph.D. degree from Delft University of Technology, The Netherlands.From 1989 to 1999, he was a Research Scientist with Philips Research Laboratories, Eindhoven, The Netherlands, where he worked on interactive displays and digital recording systems. In 1999, he joined Delft University of Technology, where he is currently an Antoni van Leeuwenhoek Professor and Head of the Microelectronics Department. His main research interests are in the design of precision mixed-signal circuits, sigma-delta modulators, smart sensors and sensor interfaces. This has resulted in 12 books, 25 patents and over 200 technical papers. Kofi Makinwa is the Analog Subcommittee Chair of the International Solid-State Circuits Conference (ISSCC). He is also on the program committees of the VLSI Symposium, the European Solid-State Circuits Conference (ESSCIRC) and the Advances in Analog Circuit Design (AACD) workshop. He has been a guest